Need to know how to adjust a Cleveland Launcher XL 2 driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Cleveland Launcher XL 2 driver and the XL 2 Draw model are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Cleveland Launcher XL 2 driver can be adjusted.

Cleveland Launcher XL 2 Drivers Lofts

The Cleveland Launcher XL 2 driver is sold in three standard lofts of 9 degrees, 10.5 degrees and 12 degrees.

The XL 2 Draw Driver is also available in 9 degrees, 10.5 degrees and 12 degrees.

Cleveland Launcher XL 2 Driver Specs

Loft: 9 degrees, 10.5 degrees & 12 degrees

Standard Length: 45.5 inches

Standard Lie: 58.5 degrees & 60 degrees

Adjustability: Loft can be adjusted by 1.5 degrees up and down (7.5-10.5 degrees, 9-12 degrees & 10.5-13.5 degrees)

Cleveland Launcher XL 2 Draw Driver

Loft: 9 degrees, 10.5 degrees & 12 degrees

Standard Length: 45.5 inches

Standard Lie: 59.5 degrees & 61 degrees

Adjustability: Loft can be adjusted by 1.5 degrees up and down (7.5-10.5 degrees, 9-12 degrees & 10.5-13.5 degrees)

Adjusting The Loft Angle of a Cleveland Launcher XL 2 Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Cleveland Launcher XL 2 driver:

1. Locate the screw on the sole of your Cleveland Launcher XL 2 driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 12 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.