How To Adjust a Cobra LTDx Driver (Adjustment Guide – Loft & Lie)

Learn how to change the loft and lie of a Cobra LTDx driver.

Need to know how to adjust a Cobra LTDx driver to switch the loft and lie angles? We have a complete guide.

The Cobra LTDx drivers range is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Cobra LTDx drivers can be adjusted.

Cobra LTDx Drivers Lofts

The Cobra LTDx driver is sold in three standard lofts of 9 degrees, 10.5 degrees, and 12 degrees.

The LTDx MAX driver also comes in 9 degrees, 10.5 degrees and 12 degrees.

The LTDx LS driver is sold in 10.5 degrees and 12 degrees.

All three are then fully adjustable to the following:

Cobra LTDx Driver Specs

Standard Length: 45.5 inches

Loft: 9 degrees, 10.5 degrees, and 12 degrees

Standard Lie: 57.5 degrees, 58.5 degrees and 59.5 degrees

Adjustability: -1.5° / -1° / -1° Draw / STD° / STD° Draw / +1° / +1° Draw / +1.5°

Cobra LTDx MAX Driver Specs

Standard Length: 45.5 inches

Loft: 9 degrees, 10.5 degrees, and 12 degrees

Standard Lie: 57.5 degrees, 58.5 degrees and 59.5 degrees

Adjustability: -1.5° / -1° / -1° Draw / STD° / STD° Draw / +1° / +1° Draw / +1.5°

Cobra LTDx LS Driver Specs

Standard Length: 45.5 inches

Loft: 10.5 degrees, and 12 degrees

Standard Lie: 58.5 degrees and 59.5 degrees

Adjustability: -1.5° / -1° / -1° Draw / STD° / STD° Draw / +1° / +1° Draw / +1.5°

Adjusting The Loft Angle of a Cobra LTDx Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Cobra LTDx driver:

1. Locate the screw on the sole of your LTDx driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.

BUY COBRA DRIVERS