How To Adjust a Honma TW777 Driver (Adjustment Guide – Loft & Lie)

Need to know how to adjust a Honma TW777 driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Honma TW777 drivers range is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Honma TW777 driver can be adjusted.

Honma TW777 Drivers Lofts

The standard TW777 model is available in 9 degrees and 10.5 degrees lofts, while the more forgiving MAX model available in 9 degrees, 10.5 degrees and 12 degrees loft options.

The 360Ti mini driver option comes in just 11.5 degrees.

Honma TW777 Driver Specs

Loft: 9 degrees & 10.5 degrees

Standard Length: 45.5 inches

Standard Lie: 59 degrees

Adjustability: Adjust Loft +/- 1 degrees Strong or Weak, Adjust Lie +2 degrees more Upright from Std and Adjust Face Angle +/- 1.5 degrees Open or Closed.

Honma TW777 MAX Driver Specs

Loft: 9 degrees, 10.5 degrees & 12 degrees

Standard Length: 45.5 inches

Standard Lie: 59 degrees

Adjustability: Adjust Loft +/- 1 degrees Strong or Weak, Adjust Lie +2 degrees more Upright from Std and Adjust Face Angle +/- 1.5 degrees Open or Closed.

Honma TW777 Ti360 Driver Specs

Loft: 11.5 degrees

Standard Length: 45.5 inches

Standard Lie: 59 degrees

Adjustability: Adjust Loft +/- 1 degrees Strong or Weak, Adjust Lie +2 degrees more Upright from Std and Adjust Face Angle +/- 1.5 degrees Open or Closed.

Adjusting The Loft Angle of a Honma TW777 Drivers

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Honma TW777 driver:

1. Locate the hosel screw on the sole of your Honma TW777 driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the hosel to a lower loft or a higher loft depending on your preference.

You will notice the wording STD, LOW, HIGH and FL on the hosel for the various settings. They can be set to the following:

• STD – Standard loft, face angle and lie
• LOW – Minus 1 degree of loft and face angle open
• HIGH – Plus 1 degree of loft and face angle closed
• FL – Minus 2 degrees of lie

4. When you have turned the non-rotating hosel to your required settings, slot the shaft back into your club head. Your new loft will be displayed.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.

BUY HONMA DRIVERS