Skip to content
Home » How To Adjust a Mizuno ST-Z 230 Driver (Adjustment Guide – Loft & Lie)

How To Adjust a Mizuno ST-Z 230 Driver (Adjustment Guide – Loft & Lie)

Mizuno ST-Z 230 Driver

Need to know how to adjust a Mizuno ST-Z 230 driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Mizuno ST-Z 230 driver is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Mizuno ST-Z 230 driver can be adjusted.

Mizuno ST-Z 230 Driver Lofts

The Mizuno ST-Z 230 driver is sold in two standard lofts of 9.5 degrees and 10.5 degrees.

Mizuno ST-Z 230 Driver Specs

Loft: 9 degrees & 10.5 degrees

Standard Length: 45 inches

Standard Lie: 57.5-60.5 degrees

Adjustability: 2 degrees of adjustability plus or minus (7-11 degrees & 8.5-12.5 degrees)

Adjusting The Loft Angle of a Mizuno ST-Z 230 Driver

Mizuno ST-Z 230 Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Mizuno ST-Z 230 driver:

1. Locate the screw on the sole of your Mizuno ST-Z 230 driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.