Need to know how to adjust Ping G425 Fairway Woods to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Ping G425 Fairway Woods are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Ping G425 Fairway Woods can be adjusted.

Ping G425 Fairway Woods Lofts

The Ping G425 Fairway Woods feature three models.

The Ping G425 MAX is sold in four standard lofts of 3-wood (14.5 degrees), 5-wood (17.5 degrees), 7-wood (20.5 degrees) and 9-wood (23.5 degrees).

The Ping G425 LST comes in 3-wood (14.5 degrees) only.

The Ping G425 SFT is sold in 3-wood (16.0 degrees), 5-wood (19.0 degrees) and 7-wood (22.0 degrees).

Ping G425 MAX Specs

Loft: 3-wood (14.5 degrees), 5-wood (17.5 degrees), 7-wood (20.5 degrees) and 9-wood (23.5 degrees)

Standard Length: 41.5 inches, 42 inches, 42.5 inches & 43 inches

Standard Lie: 56.5 degrees, 57 degrees, 57.5 degrees & 58 degrees

Adjustability: ±1.5 degrees up and down (13-16 degrees, 16-19 degrees, 19-22 degrees and 22-25 degrees).

Ping G425 LST Specs

Loft: 3-wood (14.5 degrees)

Standard Length: 43 inches

Standard Lie: 56.5 degrees

Adjustability: ±1.5 degrees up and down (13-16 degrees)

Ping G425 SFT Specs

Loft: 3-wood (16.0 degrees), 5-wood (19.0 degrees) and 7-wood (22.0 degrees)

Standard Length: 42 inches, 42 1/2 inches & 43 inches

Standard Lie: 57 degrees, 57.5 degrees & 58 degrees

Adjustability: ±1.5 degrees up and down (14.5-17.5 degrees, 17.5-20.5 degrees and 20.5-23.5 degrees)

Adjusting The Loft Angle of Ping G425 Fairway Woods

There are a few simple steps you can take to adjust the loft angle of your fairway. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust Ping G425 Fairway Woods:

1. Locate the screw on the sole of your Ping G425 Fairway Woods that attaches the fairway head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to preferred loft settings.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.