Need to know how to adjust a TaylorMade Qi10 LS driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The TaylorMade Qi10 LS driver is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

Driver adjustment amounts differ from brand to brand but the step-by-step guide below shows you how the TaylorMade Qi10 drivers range can be adjusted.

TaylorMade Qi10 LS Driver Lofts

The TaylorMade Qi10 LS driver is available in 8 degrees, 9 degrees and 10.5 degrees.

TaylorMade Qi10 LS Driver Specs

Loft: 8 degrees, 9 degrees and 10.5 degrees

Standard Length: 45.75 inches

Standard Lie: 54-58 degrees

Adjustability: Plus 2 degrees or minus 2 degrees (6-10 degrees, 7-11 degrees & 8.5-12.5 degrees). The LS also has an 18g sliding weight that can be adjusted to Fade, Draw or Neutral settings.

Adjusting The Loft Angle of a TaylorMade Qi10 LS Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a TaylorMade Qi10 LS driver:

1. Locate the screw on the sole of your TaylorMade Qi10 LS driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.