How To Adjust an XXIO 14 Driver (Adjustment Guide – Loft & Lie)

Need to know how to adjust a XXIO 14 & 14+ driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The XXIO 14 series drivers are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

It is the first time that XXIO drivers have been adjustable following the introduction of the new Quick Tune System.

The amount you can adjust a golf driver differs from brand to brand  but the step-by-step guide below shows you how the PXG Lightning drivers can be adjusted.

XXIO 14 Drivers Lofts

The XXIO 14 driver is available in 9.5 degrees, 10.5 degrees and 11.5 degrees loft options.

The XXIO 14+ is available in 9.5 and 10.5 degrees.

XXIO 14 Driver Specs

Loft: 9.5 degrees, 10.5 degrees and 11.5 degrees

Standard Length: 46 inches

Standard Lie: 59 degrees

Adjustability: Plus or minus 1.5 degrees of loft (8-11 degrees, 9-12 degrees and 10-13 degrees)

XXIO 14+ Driver Specs

Loft: 9.5 degrees and 10.5 degrees

Standard Length: 45.75 inches

Standard Lie: 59 degrees

Adjustability: Plus or minus 1.5 degrees of loft (8-11 degrees and 9-12 degrees)

Adjusting The Loft Angle of a XXIO 14 Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a XXIO 14 and 14+ driver:

1. Locate the screw on the sole of your PXG XXIO 14 and 14+ driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 12 further options.

4. When you have turned the hosel to your required loft setting on the Quick Tune System, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

6. Every time you want to adjust the loft, you repeat this process.

BUY XXIO DRIVERS