Skip to content
Home » How To Adjust PXG 0211 Fairway Woods (Adjustment Guide – Loft & Lie)

How To Adjust PXG 0211 Fairway Woods (Adjustment Guide – Loft & Lie)

Need to know how to adjust PXG 0211 Fairway Woods to switch the loft and lie angles? We have a complete guide and adjustment chart.

The PXG 0211 woods are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the PXG 0211 fairway woods can be adjusted.

PXG 0211 Fairway Woods Lofts

The PXG 0211 Fairway Woods are available in three lofts: 3 wood (15 degrees), 5 wood (18 degrees) and 7 wood (21 degrees).

PXG 0211 Fairway Woods Specs

Loft: 3 wood (15 degrees), 5 wood (18 degrees) & 7 wood (21 degrees)

Standard Length: 43 inches, 42.5 inches & 42 inches

Standard Lie: 58 degrees, 58.5 degrees & 59 degrees

Adjustability: +/- 1.5 up and down (13.5-16.5 degrees, 16.5-19.5 degrees and 19.5-22.5 degrees)

Adjusting The Loft Angle of PXG 0211 Fairway Woods

There are a few simple steps you can take to adjust the loft angle of your fairway. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust PXG 0211 Fairway Woods:

1. Locate the screw on the sole of your PXG 0211 Fairway Woods that attaches the fairway head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the club set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the clubhead is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.