How To Adjust TaylorMade M6 Woods (Adjustment Guide – Loft & Lie)

Instructions for how to adjust the loft and lie of TaylorMade M6 fairway woods

Learn how to change the loft and lie of a TaylorMade M6 Woods.

TaylorMade M6 Woods

Need to know how to adjust TaylorMade M6 Woods to switch the loft and lie angles? We have a complete guide and adjustment chart.

The TaylorMade M6 fairway woods are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the TaylorMade M6 fairways can be adjusted.

TaylorMade M6 Woods Lofts

The TaylorMade M6 Woods are sold in five standard lofts of Rocket 3 (14 degrees), 3-wood (15 degrees), 5-wood (18 degrees), 7-wood (21 degrees) and 9-wood (24 degrees).

TaylorMade M6 Woods Specs

Loft: Rocket 3 (14 degrees), 3-wood (15 degrees), 5-wood (18 degrees), 7-wood (21 degrees) and 9-wood (24 degrees).

Standard Length: 41.25 inches, 41.75 inches, 42.25 inches & 43.25 inches

Standard Lie: 59 degrees, 59.5 degrees, 60 degrees & 60.5 degrees

Adjustability: Providing +/- 2° of loft adjustability (12-16 degrees, 13-17 degrees, 16-20 degrees, 19-23 degrees & 22-26 degrees)

Adjusting The Loft Angle of TaylorMade M6 Woods

TaylorMade M6 Woods

There are a few simple steps you can take to adjust the loft angle of your fairway. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust TaylorMade M6 woods:

1. Locate the screw on the sole of your TaylorMade M6 fairways that attaches the fairway head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most clubs.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the clubhead is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.