Need to know how to adjust a Callaway Mavrik driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Callaway Mavrik drivers range is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Callaway Mavrik driver can be adjusted.

Callaway Mavrik Drivers Lofts

The Callaway Mavrik driver is sold in three standard lofts of 9 degrees, 10.5 degrees and 12 degrees.

The Mavrik Max driver is also available in 9 degrees, 10.5 degrees and 12 degrees lofts.

The Maxrik Sub Zero driver is available only in 9 degrees and 10.5 degrees.

Callaway Mavrik Driver Specs

Loft: 9 degrees, 10.5 degrees and 12 degrees

Standard Length: 45.75 inches

Standard Lie: 58 degrees

Adjustability: Up to 1 degree down or 2 degrees up (8-11 degrees, 9.5-12.5 degrees and 11-14 degrees)

Callaway Mavrik Max Driver Specs

Loft: 9 degrees, 10.5 degrees and 12 degrees

Standard Length: 45.75 inches

Standard Lie: 58 degrees

Adjustability: Up to 1 degree down or 2 degrees up (8-11 degrees, 9.5-12.5 degrees and 11-14 degrees)

Callaway Mavrik Max Driver Specs

Loft: 9 degrees and 10.5 degrees

Standard Length: 45.75 inches

Standard Lie: 58 degrees

Adjustability: Up to 1 degree down or 2 degrees up (8-11 degrees and 9.5-12.5 degrees)

Adjusting The Loft Angle of a Callaway Mavrik Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Callaway Mavrik driver:

1. Locate the screw on the sole of your Callaway Mavrik driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.