How To Adjust a Cobra King TEC Mini Driver (Adjustment Guide – Loft & Lie)

Need to know how to adjust a Cobra King TEC Mini Driver to switch the loft and lie angles? We have a complete guide to the FutureFit33 hosel.

The Cobra King TEC Mini driver is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle thanks to the FutureFit33 hosel with up to 33 different loft and lie settings.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Cobra King TEC Mini Driver can be adjusted.

Cobra King TEC Mini Driver Lofts

The Mini Driver comes in standard loft of 13.5 degrees, which can be adjustable by four degrees (2 up and 2 down). The hosel also allows for a 2-degree flatter lie setting.

Cobra King TEC Mini Driver Specs

Loft: 13.5 degrees

Standard Length: 43.75 inches

Standard Lie: 58.5 degrees standard lie

Adjustability: 11.5-15.5 degrees of loft and 56.5-60.5 degrees of lie

Adjusting The Loft Angle of a Cobra King TEC Mini Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Cobra King TEC Mini Driver:

1. Locate the screw on the sole of your Mini Driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 33 further options.

The available options from the FutureFit33 hosel adjustment are:

Examples:

• Fight a Slice: Use upright lie settings or closed face angles (e.g., B1, C1, or C8) to promote a draw
• Fix a Hook: Use flatter lie settings or open face angles (e.g., A8, A7, or B6) to promote a fade
• Maximize Distance / High Launch: Increase loft (move up the chart, e.g., F4 or G3)
• Control in Wind / Low Launch: Use lower loft settings like G3, G4 or F3

4. When you have turned the hosel to your required loft and lie setting, slot the shaft back into your club head. Your new loft will be displayed through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft or lie, you repeat this process.

BUY COBRA DRIVERS