Skip to content
Home » How To Adjust a Honma TW757 Driver (Adjustment Guide – Loft & Lie)

How To Adjust a Honma TW757 Driver (Adjustment Guide – Loft & Lie)

Honma TW757 Drivers

Need to know how to adjust a Honma TW757 driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Honma TW757 driver is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Honma TW757 driver can be adjusted.

Honma TW757 Drivers Lofts

The Honma TW757 driver has two models in the series.

The TW757 D, known as Directional Control, is sold in two standard lofts of 9 degrees and 10.5 degrees.

The TW757 S, which gets the name from Spin and Stability Control, is also sold in 9 degrees and 10.5 degrees.

Honma TW757 D Driver Specs

Standard Length: 45.5 inches

Loft: 9 degrees & 10.5 degrees

Standard Lie: 57.5 degrees

Adjustability: Adjust Loft +/- 1 degrees Strong or Weak, Adjust Lie +2 degrees more Upright from Std and Adjust Face Angle +/- 1.5 degrees Open or Closed.

Honma TW757 S Driver Specs

Standard Length: 45.5 inches

Loft: 9 degrees & 10.5 degrees

Standard Lie: 57.5 degrees

Adjustability: Adjust Loft +/- 1 degrees Strong or Weak, Adjust Lie +2 degrees more Upright from Std and Adjust Face Angle +/- 1.5 degrees Open or Closed.

Adjusting The Loft Angle of a Honma TW757 Drivers

Honma TW757 S Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Honma TW757 driver:

1. Locate the screw on the sole of your Honma TW757 driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.