Need to know how to adjust a PXG 0311 GEN6 driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The PXG 0311 GEN6 driver is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the PXG 0311 GEN6 driver can be adjusted.

PXG 0311 GEN6 Drivers Lofts

The PXG 0311 GEN 6 driver is sold in three standard lofts of 7.5 degrees, 9 degrees and 10.5 degrees.

The PXG 0311 GEN6 XF driver is available in 9 degrees, 10.5 degrees and 12 degrees lofts.

PXG 0311 GEN6 Driver Specs

Loft: 7.5 degrees, 9 degrees and 10.5 degrees

Standard Length: 45.5 inches

Standard Lie: 59 degrees

Adjustability: Plus or minus 1.5 degrees of loft. The 0311 also comes with one 2.5g and two 7.5g weights on the sole to offer the adjustability to suit all swing types and ball shapes. 

PXG 0311 GEN6 XF Driver Specs

Loft: 9 degrees, 10.5 degrees and 12 degrees

Standard Length: 45.5 inches

Standard Lie: 59 degrees

Adjustability: Plus or minus 1.5 degrees of loft. The driver also comes with one 2.5g and two 7.5g weights on the sole to offer the adjustability to suit all swing types and ball shapes. 

Adjusting The Loft Angle of a PXG 0311 GEN6 Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a PXG 0311 GEN6 driver:

1. Locate the screw on the sole of your PXG 0311 GEN6 driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to explore further loft options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.