Skip to content
Home » How To Adjust a TaylorMade BRNR Mini Driver (Adjustment Guide – Loft & Lie)

How To Adjust a TaylorMade BRNR Mini Driver (Adjustment Guide – Loft & Lie)

TaylorMade BRNR Mini Driver

Need to know how to adjust a TaylorMade BRNR Mini driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The amount of driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the TaylorMade BRNR Mini driver an be adjusted.

TaylorMade BRNR Mini Drivers Lofts

The 2023 TaylorMade BRNR Mini driver is sold in two loft options of 11.5 degrees and 13.5 degrees.

TaylorMade BRNR Mini Driver Specs

Loft: 11.5 degrees and 13.5 degrees

Standard Length: 43.75 inches

Standard Lie: 57 degrees

Adjustability: Plus or minus 2 degrees (9.5-13.5 degrees and 11.5-15.5 degrees)

Adjusting The Loft Angle of a TaylorMade BRNR Mini Driver

TaylorMade BRNR Mini Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a TaylorMade BRNR Mini driver:

1. Locate the screw on the sole of your TaylorMade BRNR Mini driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.