Need to know how to adjust a Titleist TSi3 Fairway Woods to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Titleist TSi3 woods is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Titleist TSi3 fairway woods can be adjusted.

Titleist TSi3 Fairway Woods Lofts

The Titleist TSi3 Fairway Woods are sold in four standard lofts of 13.5 degrees, 15 degrees, 16.5 degrees and 18 degrees.

Titleist TSi3 Fairway Woods Specs

Loft: 13.5 degrees, 15 degrees, 16.5 degrees & 18 degrees

Standard Length: 42 inches, 42.5 inches & 43 inches

Standard Lie: 56.5 degrees, 57 degrees & 57.5 degrees

Adjustability: Can be adjusted in increments of 0.75° for both the loft and lie angle. +/- 1.5 degrees in total (12-15 degrees, 13.5-16.5 degrees, 15-18 degrees and 16.5-19.5 degrees)

Adjusting The Loft Angle of Titleist TSi3 Fairway Woods

There are a few simple steps you can take to adjust the loft angle of your fairway. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Titleist TSi3 Fairway Woods:

1. Locate the screw on the sole of your Titleist TSi3 woods that attaches the fairway head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most clubs.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the clubhead is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.