Need to know how to adjust TaylorMade Stealth 2 rescues to switch the loft and lie angles? We have a complete guide and adjustment chart.

The TaylorMade Stealth 2 Plus rescues are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle, however, the standard Stealth 2 model isn’t adjustable.

The amount of adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the TaylorMade Stealth 2 hybrids can be adjusted.

TaylorMade Stealth 2 Rescues Lofts

The TaylorMade Stealth 2 rescues are available in lofts of 3-rescue (17 degrees), 4-rescue (22 degrees), 5-rescue (25 degrees), 6-rescue (28 degrees) and 7-rescue (31 degrees).

The TaylorMade Stealth 2 Plus rescues are available in 2-hybrid (17 degrees), 3-hybrid (19.5 degrees) and 4-hybrid (22 degrees).

TaylorMade Stealth 2 Rescues Specs

Loft: 3-rescue (17 degrees), 4-rescue (22 degrees), 5-rescue (25 degrees), 6-rescue (28 degrees) and 7-rescue (31 degrees).

Standard Length: 40.75 inches to 38.75 inches

Standard Lie: 60 degrees to 62 degrees

Adjustability: Non-adjustable

TaylorMade Stealth 2 Plus Rescues Specs

Loft: 2-hybrid (17 degrees), 3-hybrid (19.5 degrees) and 4-hybrid (22 degrees).

Standard Length: 40.75 inches to 39.75 inches

Standard Lie: 56.5 degrees to 60.5 degrees

Adjustability: Providing +/- 1.5° of loft adjustability (15.5-18.5 degrees, 18-21 degrees & 20.5-23.5 degrees)

Adjusting The Loft Angle of TaylorMade Stealth 2 Rescues

There are a few simple steps you can take to adjust the loft angle of your hybrid. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust TaylorMade Stealth 2 Plus Rescues:

1. Locate the screw on the sole of your TaylorMade 2 Stealth rescues that attaches the head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the clubhead is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.