How To Adjust a TaylorMade M4 Driver (Adjustment Guide – Loft & Lie)

Instructions for how to adjust the loft and lie of a TaylorMade M4 driver

Learn how to change the loft and lie of a TaylorMade M4 driver.

TaylorMade M4 Driver

Need to know how to adjust a TaylorMade M4 driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the TaylorMade M4 driver an be adjusted.

TaylorMade M4 Drivers Lofts

The TaylorMade M4 driver is sold in three standard lofts of 9.5 degrees, 10.5 degrees, and 12 degrees.

TaylorMade M4 Driver Specs

Loft: 9.5 degrees, 10.5 degrees, and 12 degrees

Standard Length: 45.75 inches

Standard Lie: 56-60 degrees

Adjustability: Plus or minus 2 degrees (7.5-11.5 degrees, 8.5-12.5 degrees and 10-14 degrees)

Adjusting The Loft Angle of a TaylorMade M4 Driver

TaylorMade M4 Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a TaylorMade M4 driver:

1. Locate the screw on the sole of your TaylorMade M4 driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.