Need to know how to adjust Callaway AI Smoke Triple Diamond woods to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Callaway AI Smoke fairway woods is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Callaway Paradym AI Smoke Triple Diamond woods can be adjusted.

Callaway AI Smoke Triple Diamond Woods Lofts

The Callaway AI Smoke Triple Diamond Woods are sold in 3-wood (15 degrees), 5-wood (18 degrees) and 7-wood (21 degrees).

Callaway Paradym Triple Diamond Fairway Woods Specs

Loft: 3-wood (15 degrees), 5-wood (18 degrees) and 7-wood (21 degrees)

Standard Length: 42.25 inches to 43.25 inches

Standard Lie: 56 degrees to 57 degrees

Adjustability: The 3-wood has an adjustable hosel for up to four degrees of adjustability (two degrees up and down).

Adjusting The Loft Angle of Callaway AI Smoke Triple Diamond Woods

There are a few simple steps you can take to adjust the loft angle of your fairway. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Callaway Paradym AI Smoke Triple Diamond fairway wood:

1. Locate the screw on the sole of your Callaway AI Smoke woods that attaches the fairway head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.