Need to know how to adjust Ping G430 hybrids to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Ping G430 rescues are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Ping G430 hybrids can be adjusted.

Ping G430 Hybrids Lofts

The Ping G430 hybrids are available in 2-hybrid (17.0 degrees), 3-hybrid (19.0 degrees), 4-hybrid (22.0 degrees), 5-hybrid (26.0 degrees), 6-hybrid (30.0 degrees) and 7-hybrid (34.0 degrees).

Ping G430 Rescues Specs

Loft: 2-hybrid (17.0 degrees), 3-hybrid (19.0 degrees), 4-hybrid (22.0 degrees), 5-hybrid (26.0 degrees), 6-hybrid (30.0 degrees) and 7-hybrid (34.0 degrees)

Standard Length: 40.75 inches to 38.25 inches

Standard Lie: 57 degrees to & 59.5 degrees

Adjustability: Plus or minus 1.5 degrees up and down (15.5-18.5 degrees, 17.5-20.5 degrees, 20.5-23.5 degrees, 24.5-27.5 degrees, 28.5-31.5 degrees and 32.5-35.5 degrees).

Adjusting The Loft Angle of Ping G430 Hybrids

There are a few simple steps you can take to adjust the loft angle of your hybrid. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust Ping G430 hybrids:

1. Locate the screw on the sole of your Ping G430 rescues that attaches the club head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to preferred loft settings.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most clubs.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the clubhead is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.