Need to know how to adjust a PXG 0311 GEN5 Fairway Woods to switch the loft and lie angles? We have a complete guide and adjustment chart.
The PXG 0311 GEN5 woods are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.
The amount of adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the PXG 0311 GEN5 fairway woods can be adjusted.
PXG 0311 GEN5 Woods Lofts
The PXG 0311 GEN5 Fairway Woods are sold in four standard lofts of 2-wood (13 degrees), 3-wood (15 degrees), 5-wood (18 degrees) and 7-wood (21 degrees).
The PXG 0311 XF GEN5 Fairway Woods are available in 3-wood (16 degrees), 4-wood (17 degrees), 5-wood (19 degrees) and 7-wood (22 degrees) options.
PXG 0311 GEN5 Fairway Woods Specs
Loft: 2-wood (13 degrees), 3-wood (15 degrees), 5-wood (18 degrees) and 7-wood (21 degrees)
Standard Length: 43.5 inches, 43 inches, 42.5 inches & 42 inches
Standard Lie: 59 degrees, 58.5 degrees, 58 degrees & 57.5 degrees
Adjustability: +/- 1.5 degrees of adjustability (11.5-14.5 degrees, 13.5-16.5 degrees, 16.5-19.5 degrees & 19.5-22.5 degrees)
PXG 0311 XF GEN5 Fairway Woods Specs
Loft: 3-wood (16 degrees), 4-wood (17 degrees), 5-wood (19 degrees) and 7-wood (22 degrees)
Standard Length: 43 inches, 42.5 inches & 42 inches
Standard Lie: 59.5 degrees, 58.5 degrees & 58 degrees
Adjustability: +/- 1.5 degrees of adjustability (14.5-17.5 degrees, 15.5-18.5 degrees, 17.5-20.5 degrees & 20.5-23.5 degrees)
Adjusting The Loft Angle of PXG 0311 GEN5 Fairway Woods
There are a few simple steps you can take to adjust the loft angle of your fairway. You will just need an adjustment tool or wrench to get started.
Here’s how to adjust PXG 0311 GEN5 Fairway Woods:
1. Locate the screw on the sole of your PXG 0311 GEN5 Fairway Woods that attaches the fairway head to the shaft.
2. Using the wrench, loosen the screw by turning anticlockwise.
3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.
4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.
5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the clubhead is cracking. At this point, the screw is as tight as needed.
Every time you want to adjust the loft, you repeat this process.
The Golf Reviews Guide team provide honest analysis of courses worldwide, information on the best golf destinations to visit, reviews the latest products and golf equipment and up to the minute golf news from the tours.