How To Adjust Titleist TSR2 Woods (Adjustment Guide – Loft & Lie)

Instructions for how to adjust the loft and lie of Titleist TSR2 fairway woods

Learn how to change the loft and lie of Titleist TSR2 Woods.

Titleist TSR2 Woods

Need to know how to adjust Titleist TSR2 woods to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Titleist TSR2 woods have fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Titleist TSR2 fairway woods can be adjusted.

Titleist TSR2 Woods Lofts

The Titleist TSR2 Woods are sold in four standard lofts of 15 degrees, 16.5 degrees, 18 degrees and 21 degrees.

Titleist TSR2 Woods Specs

Loft: 15 degrees, 16.5 degrees, 18 degrees & 21 degrees

Standard Length: 41.5 inches, 42 inches & 43 inches

Standard Lie: 56.5 degrees, 57 degrees, 57.5 degrees & 58 degrees

Adjustability: +/- 1.5 degrees (13.5-16.5 degrees, 15-18 degrees, 16.5-19.5 degrees & 19.5-22.5 degrees)

Adjusting The Loft Angle of a Titleist TSR2 Woods

Titleist TSR2+ Woods

There are a few simple steps you can take to adjust the loft angle of your fairway. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Titleist TSR2 Woods:

1. Locate the screw on the sole of your Titleist TSR2 woods that attaches the fairway head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the club is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.