How To Adjust a Ping G440 Driver (Adjustment Guide – Loft & Lie)

Need to know how to adjust a Ping G440 driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Ping G440 drivers are fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Ping G440 drivers range can be adjusted.

Ping G440 Drivers Lofts

There are our models in the Ping G440 drivers series.

The Max driver is available in 9 degrees, 10.5 degrees and 12 degrees, while the LST and SFT drivers are available in 9 degrees and 10.5 degrees. There are also HL (High Launch) versions of the Max and SFT models.

In 2026, the G440 K was added to the series with 9 degrees, 10.5 degrees and 12 degrees lofts and a High Launch (HL) version for slower swings.

Ping G440 Max Driver Specs

Loft: 9 degrees, 10.5 degrees and 12 degrees

Standard Length: 45.75 inches

Standard Lie: 58.5 degrees

Adjustability: Plus or minus 1.5 degrees (7.5-10.5 degrees, 9-12 degrees and 10.5-13.5 degrees)

Ping G440 SFT Driver Specs

Loft: 9 degrees & 10.5 degrees

Standard Length: 45.75 inches

Standard Lie: 57 degrees

Adjustability: Plus or minus 1.5 degrees (7.5-10.5 degrees and 9-12 degrees)

Ping G440 LST Driver Specs

Loft: 9 degrees & 10.5 degrees

Standard Length: 45.75 inches

Standard Lie: 57 degrees

Adjustability: Plus or minus 1.5 degrees (7.5-10.5 degrees and 9-12 degrees)

Ping G440 K Driver Specs

Loft: 9 degrees, 10.5 degrees & 12 degrees

Standard Length: 46 inches

Standard Lie: 58.5 degrees

Adjustability: Plus or minus 1.5 degrees (7.5-10.5 degrees, 9-12 degrees and 10.5-13.5 degrees)

Adjusting The Loft Angle of a Ping G440 Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Ping G440 driver:

1. Locate the screw on the sole of your Ping G440 driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to 16 further options.

• 0 is Standard setting
• Big + is +1.5° loft of loft
• Small + is +1.0° loft of loft
• Big – is -1.5° of loft
• Small – is -1.0° of loft

4. When you have turned the hosel to your required loft, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.

BUY PING DRIVERS