How To Adjust a Callaway Elyte Driver (Adjustment Guide – Loft & Lie)

Need to know how to adjust a Callaway Elyte driver to switch the loft and lie angles? We have a complete guide and adjustment chart.

The Callaway Elyte driver series was launched in 2025 and is fully adjustable with a hosel offering you the opportunity to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment you can make differs from brand to brand but the step-by-step guide below shows you how the Callaway Elyte drivers can be adjusted.

Callaway Elyte Drivers Lofts

The Elyte and Elyte X models are available in 9 degrees, 10.5 degrees and 12 degrees.

The Max Fast is sold in 10.5 degrees and 12 degrees, and the Triple Diamond in 8 degrees, 9 degrees and 10.5 degrees.

All four drivers come with three degrees of adjustability (one degree down and two degrees up) and various weight adjustment options available in each model.

Callaway Elyte Driver Specs

Loft: 9 degrees, 10.5 degrees & 12 degrees

Standard Length: 45.75 inches

Standard Lie: 57 degrees

Adjustability: Three degrees of adjustment (8-11 degrees, 9.5-12.5 degrees and 11-14 degrees). There is also an adjustable rear weight in this model that can be positioned in neutral, draw or fade settings.

Callaway Elyte X Driver Specs

Loft: 9 degrees, 10.5 degrees & 12 degrees

Standard Length: 45.75 inches

Standard Lie: 59 degrees

Adjustability: Three degrees of adjustment (8-11 degrees, 9.5-12.5 degrees and 11-14 degrees). There is also an adjustable rear weight in this model that can be positioned in neutral or draw settings.

Callaway Elyte Max Fast Driver Specs

Loft: 10.5 degrees & 12 degrees

Standard Length: 45.75 inches

Standard Lie: 59 degrees

Adjustability: Three degrees of adjustment (9.5-12.5 degrees and 11-14 degrees). There is also an adjustable rear weight in this model that can be positioned in neutral or draw settings.

Callaway Elyte Triple Diamond Driver Specs

Loft: 8 degrees, 9 degrees & 10.5 degrees

Standard Length: 45.75 inches

Standard Lie: 57 degrees

Adjustability: Three degrees of adjustment (7-10 degrees, 8-11 degrees, 9.5-12.5 degrees)

Adjusting The Loft Angle of a Callaway Elyte Driver

There are a few simple steps you can take to adjust the loft angle of your driver. You will just need an adjustment tool or wrench to get started.

Here’s how to adjust a Callaway Elyte driver:

1. Locate the screw on the sole of your Callaway Elyte driver that attaches the driver head to the shaft.

2. Using the wrench, loosen the screw by turning anticlockwise.

3. Once the screw is fully out, you can rotate the adjustable hosel to a lower loft or a higher loft depending on your preference. You will notice the loft figure you had the driver set to and be able to turn the shaft to up to eight further options.

The settings on a Callaway hosel mean the following:

• S: The stated loft, which is the loft stamped on the clubhead
• -1: Subtracts one degree from the stated loft
• +1: Adds one degree to the stated loft
• +2: Adds two degrees to the stated loft
• N: Neutral lie setting
• D: Draw lie setting, which makes the club more upright

4. When you have turned the hosel to your required loft and lie, slot the shaft back into your club head. Your new loft will be display through the window on most drivers.

5. Put the screw back in place and tighten with the wrench by turning clockwise. When it is fully tight, you will hear a crank that sounds like the driver is cracking. At this point, the screw is as tight as needed.

Every time you want to adjust the loft, you repeat this process.

BUY CALLAWAY DRIVERS